Back to: Speaker Management

DBX - DRIVERACK 4820

Print
Description
Input  (4) total 
Input Connectors Female XLR 
Input Type Electronically balanced, RF filtered
Insert Impedance  >50k ohm
Max Input Software selectable for: +28, +26, +24, +22, +20, +18, +16, +14 dBu
CMRR >40 dB typical, >55 dB at 1 kHz
Digital Inputs (4) AES/EBU Channels
Digital Input Connectors Female XLR
Digital Input Type Transformer Isolated, RF filtered
Digital Input Impedance >110 ohms
Mic Preamp Connector (RTA) - (1) Female XLR
Mic Preamp gain (RTA) 10dB to 50dB in 10dB increments
Output 8 total
Output Connectors Male XLR
Output Type Electronically balanced, RF filtered
Output Impedance 30 ohms
Max Output Software selectable for: +24, +22, +20, +12, +8, +4 dBu
Digital Output (8) AES/EBU Channels
Digital Output Connector Male XLR
Digital Output Type Transformer Isolated, RF filtered
Digital Output Impedance >110 ohms
A/D Converter dbx Typve IV™ Converstion System
A/D Dynamic Range >114 dB unweighted, 116dB A-weighted
Type IV Dynamic Range 128dB with transient material, A-weighted, 22kHz BW 126 dB with transient material, unweighted, 22 kHz BW 120 dB typical with program material, A-weighted, 22 kHz BW
Sample Rate 96kHz
Wordlength 24 bits
D/A Dynamic Range 112 dB unweighted, 115 dB A-weighted
Dynamic Range 112dB unweighted, 115dB A-weighted
Internal Processing 32 bit floating point
THD+Noise 0.004% typical at +4 dBu, 1 kHz, 0 dB input gain
Frequency Response 20 Hz- 40 kHz, +/-0.5 dB
Interchannel Crosstalk <-85 dB at 1 kHz, 0 dB input gain
Pre EQ Type One 31-band Graphic EQ on each input One EQ that is switchable between 31-band and 9-band Parametric on each input
EQ Gain +/- 12dB
Input Insert Processing Two selectable Insert Processing blocks per input: Noise Gate, Compressor, Auto Gain Control, De-Esser, Sub-Harmonic Synth, Advanced Feedback Suppression
Input Delay Length Up to 682 mSec available
Routing/Mixing 4-input mixer available at each output allowing any input to be sent or mixed to any output
Output Insert Processing Two selectable Insert Processing blocks per output: Noise Gate, AutoWarmth®, Compressor, Auto Gain Control, Peak Limiter, Sub-Harmonic Synth, Advanced Feedback Suppression
Crossover configs: 1x1, 1x2, 1x3, 1x4, 1x5, 1x6, 1x7, 1x8, 2x2, 2x3, 2x4 2x5, 2x6, 2x7, 2x8, 3x3, 3x4, 3x6, 3x7, 4x4, 4x5, 4x8